Stacking Switches | Junos OS - Juniper Networks
How can I stack mutliple Juniper Switches (EX4200)? parau 06-30-2014 22:45.
Preferred way to stack EX 3400 switches | Switching - Juniper …
Feb 12, 2020 · On all of these switches, the SFP+ uplink ports, which support 10-Gbps speeds and can connect switches that are up to 6.2 miles (10 km) apart, can be configured into VCPs. As far as stacking cable is concerned i am not sure but they are not shipped with the switches itself.
Heat output from EX switches | Switching - Juniper Networks
Aug 3, 2017 · usually your local Juniper Partner should be able to get hold of this information. There is a document provided to Juniper and Partner SE's with precise numbers for wiring closet switches with different traffic and PoE load. I'm not allowed to give out these numbers in a public forum - so you need to go via your local partner. -- Best regards,
Recommended replacement switches | Switching - Juniper Networks
Oct 31, 2019 · Recommended replacement switches Jump to Best Answer. StarLog 10-31-2019 06:25. We have a VC consisting of ...
what is protocol like VTP on juniper EX switches? | Switching
Feb 19, 2013 · I did hear that MVRP is supported on EX switches as of 10.0. From what little I have read on that protocol, it sounds like you need to do the VLAN configuration at the Access layer and enable MVRP on the trunk port connecting to the Distibution layer.
MAC machines and juniper switches | Switching
Is there any special configuration required in juniper switches to have MAC machines to communicate each other. The issue is that the guy who supporting MAC machine complaints that the MAC clients can not see the services configured between them. Could someone help me with any advice. These clients are distributed across different juniper switches.
DHCP helper and PXE Boot configuration | Junos OS - Juniper …
Oct 16, 2018 · So this lead me to thing that either there's a issue with the pxe client or the switches does let pass pxe/tftp traffic properly. Any thoughs about this ? I am about to open a case with Juniper, though that I not convice if it's an issue with switches configuration or something else.
Switching - Juniper Networks
Apr 14, 2009 · I am new to network administration and also Juniper, so I am learning as quickly as I can, but also avoiding asking too many silly questions along the way. So, the answer is: to find MAC addresses for devices that connects to our SRX 5800 Firewall, one has to ping it to populate the ARP table and from there get the MAC address. Thank you again.
random high latency issues on ex2300 series switches | Switching
The delay/blocking behaviour is the same with or without dot1x configuration. All swithces run ntp to get correct time and I routinely remove the "irb unit 0 family inet dhcp vendor-id" from all Juniper switches. PS: Thus far I have not seen this behaviour in EX2300-MP units.
Switches managed by Mist | Switching - Juniper Networks
May 24, 2022 · I am running a POC to decide if moving from Cisco to Juniper is right for the business. As of right now I am seeing a difference in the configuration on the switches from what is set up in Mist. "Configuration is Managed by Mist" is enabled I was unable to setup the VC and so Support assisted with pre-provisioned VC.