Enabling or disabling ports and configuring port mode
To configure port C5 for auto-10-100, enter this command: (HP_Switch_name#) int c5 speed-duplex auto-10-100 To configure ports C1 through C3 and port C6 for 100Mbps full-duplex, enter these commands:
Port Status and Configuration - Hewlett Packard Enterprise …
With the port mode set to Auto (the default) and flow control enabled, the switch negotiates flow control on the indicated port. If the port mode is not set to Auto, or if flow control is disabled on the port, flow control is not used.
Port status and configuration - Hewlett Packard Enterprise …
Use the following commands to display port status and configuration data. Lists the current operating status for all ports on the switch. Lists a subset of configuration data for all ports on the switch; that is, for each port, the display shows whether the port is enabled, the operating mode, and whether it is configured for flow control.
HPE 1920 - how to enable disable port using telnet / cli
Dec 1, 2016 · How To Disable and Enable Ports on the E-Series and A-Series Switches from HP... A simple guide on to enable, disable and manage all of your ports on the HP e series procurve and the HP a series ports.
HP Procurve CLI Cheat Sheet - Hardware - Spiceworks Community
Jul 11, 2014 · A list of basic commands for HP switches I find helpful. The commands are written for a 5400 running firmware K.15.13.0005, however, should be similar for any switch with a recent firmware release. Notes: <> indicates a changable variable, such as port number or VLAN ID.
How To Disable and Enable Ports on the E-Series and A-Series Switches …
Oct 4, 2012 · Below you will find commands on how to disable and enable ports on the HP procurve E-series and the A-series. This can be done on individual ports, ranges or you can actually disable or enable all of the ports.
How to enable/disable a port in HP ProCurve Switch - Step by …
How to enable/disable a port in HP ProCurve Switch - Step by step with screenshots. 1. Login HP Switch Web Utility. 2. Click Configuration and then Port Configuration. 3. Highlight the Port you want to enable or disable. 4. Click Enable selected Ports or Disable Selected Ports. Post your questions, comments, feedbacks and suggestions
The four VLAN parameters you can configure for each port on the switch include VLAN Aware Enabled, Ingress Filtering Enabled, Packet Type, and PVID. Note that the ports within a trunk cannot be configured individually; configure the trunk instead (trunks are labelled T1 to T12 for the 24 port switch, and T1 to T4 for the 8 port switch).
Using the CLI - Hewlett Packard Enterprise Support Center
Includes port-or trunk-specific commands that apply only to the selected port(s) or trunk group, plus the global configuration, Manager, and Operator commands. The prompt for this mode includes the identity of the selected port(s): HP Switch(config)# interface c3-c6 HP Switch(eth-C5-C8)# HP Switch(config)# interface trk1 HP Switch(eth-Trk1)#
Tech Short: How To Disable and Enable Ports HP ProCurve
Apr 3, 2015 · To disable a single or multiple ports we do the following. Log into your switch via console (in my case I SSH in using Putty) When connected type: configure. Then issue the following command (note you can tab complete) If you were to enable a disabled port you simply you use the enable command.
- Some results have been hidden because they may be inaccessible to you.Show inaccessible results