Where do I attach the engine leveler? | Vintage Mustang Forums
Oct 6, 2003 · Here is the test to find whether your Mustang is finished: if you're alive, it isn't. @===------,------,------,------. I have had good success by removing the intake and then bolting the chains to the block with 4 grade eight bolts and matching washers.
I've got me an engine hoist and leveler, now what else do i need?
Aug 21, 2009 · Borrowing an engine hoist and leveler from work to run down to pullman (90 minutes south) to pull the engine out of my '67. I'd like to pull the engine and transmission all at once but i've never pulled an engine before. What size sockets, breaker bars, etc, will i need?
How to Remove a 1968 289 engine and overhaul the compartment
Mar 7, 2011 · An engine leveler will help a lot but I've done it alone with just a 3 hole plate attached to the intake and lifted by the rear hole to give the most tilt coming out. Lots of heavy carpet/towels to protect stuff.
Pulled the Engine/Trans Today - Vintage Mustang Forums
Mar 16, 2024 · Never pulled engine and tranny at once, but I've removed two engines and installed two. Used the leveler both times, and found it made both jobs much easier, being able to tweak the angle just a little when necessary.
Best way to lift motor | Mustang Forums at StangNet
May 4, 2011 · Are you putting in the engine and transmission together? In my 67 I pulled and installed my 289 & c4 with a simple chain hoist and no load leveler, the transmission was enough counter on the rear to nearly bring the engine out perfectly, even left the crank pulley on (it was REAL tight though).
Removing the Engine and Transmission - Average Joe Restoration
Mar 10, 2014 · An engine leveler will make it possible to remove and install the transmission together so this is a must have piece of tooling. Aside from an engine stand you will also need a handful of tools to get the job done.
1966 Mustang engine removal procedure | Ford Mustang Forum
Feb 8, 2012 · I had my car on the ground when I both pulled and installed the engine/transmission as one piece. But I also use a leveler so I can crank the engine back at a steep angle so the transmission can clear. Maybe that's really bad...
Leveler tech/safety - Ford Mustang Forum
Feb 28, 2012 · Model Specific Forums. Classic Mustang Forums. Classic Tech
Step by step for engine removal | Vintage Mustang Forums
Sep 21, 2004 · Pulling with the tranny definately requires the adjustable leveler (so you can tilt the engine back). Alse, you will have to set the lift lever so that its as long as is safe (1000lb minimum i would guess).
Where to attach engine leveler?? - Ford Mustang Forums
May 20, 2010 · Putting the engine/tranny back in tomorrow. I have an engine leveler attached to my hoist. The leveler has chain to attach to 2 places front & 2 places at...