This car stereo booster uses an LM2896 IC which has two integrated amplifiers. It can be powered with voltages up to 15 volts. The power output is 2.5 watts per channel with an 8 Ω load and supply ...

The circuit uses only one IC, the well-known LM317, a low-cost power-supply regulator. Using this chip, you can modulate the adjustment-pin input with the audio signal from an electret condenser ...

9 thoughts on “ Hybrid Lab Power Supply From Broken Audio Amp ” aroundwaves says: June 18, 2018 at 11:26 pm my variation of DIY powersupply (dual type linear and DC/DC convertion) https ...

The GaN400 is a “class-D” stereo power amplifier that utilizes GaNFETs (Gallium Nitride Field-Effect Transistors), an 850-watt RMS regulated power supply, a fully balanced topology and a low global ...

So I'm finalising a set-up for my new build & I'd really like to get it right this time. I have an amplifier rated at RMS 330 watts (Max 600) x 1 channel at 4Ohms (from Sony) So Am I Better Off ...

New High-Efficiency M1200.2, M700.2 and M300.2 Amps Combine High Performance, Low-Noise TriPath Technology and Multiple Power Options. Carver Digital, a division of Phoenix Gold International, Inc., ...

Current dumping amplifier schematics always looked strange to me. I am considering building one, just to try one out. Solid tantalum capacitors strike again.

The standard requires using a power-supply of 14.4 volts into a 4-ohm impedance and achieving THD of 1 ... No discussion of car audio amplifiers would be complete without covering amplifier ...

In an enclosure smaller than your average BOSS stompbox, and that's your power amp. Simply build your rig around it on the pedalboard. As Carvin demonstrates on their site, their all-tube X1 preamp ...

Texas Instruments introduced a family of four digital-input, closed-loop I2S amplifiers for mid-power stereo audio applications including TVs, soundbars, portable docking stations, Bluetooth ...